---
title: "Agfa D-Workflow"
sidebarTitle: "Overview"
description: "Configure the Agfa D-Workflow interface so the APM or Lab 50 software can convert and print orders through D-Workflow."
keywords:
  - "agfa"
  - "printer"
  - "dworkflow"
  - "dwf"
  - "d"
  - "workflow"
  - "msc"
  - "101d"
---

> **For AI agents:** the complete documentation index is at [llms.txt](/llms.txt). Append `.md` to any page URL for its markdown version.

The Agfa D-Workflow interface allows the APM or Lab 50 software to convert orders generated from an APM into a format that D-Workflow (version 2.64 or higher) can accept and print.

### Prerequisites

1. The APM and/or Lab 50 software needs to be able to see the D-Workflow machine across the local area network and vice versa.
2. D-Workflow must be on version 2.64 or higher and use 28k ATTY files on the APM/Lab 50 and D-Workflow machines.
3. If Lab 50 is not present in the local installation, then at least one or more fulfillments must be enabled to print to a local printer connected to the APM. This is seen in the screenshot below, taken from the main options of an enabled fulfillment in the Setup Wizard.

|                             |
|:----------------------------|
| ![Print Settings](/images/printer-guides/agfa-d-workflow/printsettings.jpg) |
| Print Settings              |

### Setting up the D-Workflow Using Setup Wizard

The Setup Wizard is used to configure the APM to print to the D-Workflow Interface.

**This process includes the following steps:**

1. Adding the printer interface and editing the general settings.
2. Product setup from within the interface.
3. Assigning printable products to the interface.